Cart 0
PIR Motion Sensor (JST)

PIR Motion Sensor (JST)

$ 11.05
We currently have 4 in stock at Jacobs Hall.

The store is currently closed.


Description: This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the ‰Û÷alarm‰۪ pin will go low.

This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V.

The alarm pin is an open collector meaning you will need a pull up resistor on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin. If any of the motion sensors go off, the input pin will be pulled low.

We‰۪ve finally updated the connector! Gone is the old ‰ÛÏodd‰۝ connector, now you will find a common 3-pin JST! This makes the PIR Sensor much more accessible for whatever your project may need. Red = Power, White = Ground, and Black = Alarm.

More from this collection